DriverZone.com: The place to find device driver updates.

************************************************************************
PROVIEW ELECTRONICS CORPORATION Revision Date:Aug 6,1998
************************************************************************
Use the information file (PROVIEW.INF) for Microsoft Windows 95/98

CONTENTS
========
1.0 Introduction

2.0 Installing the *.INF file

3.0 Troubleshooting

1.0 Introduction
=================

PROVIEW Plug & Play monitors are designed to work with Windows'95/98
operating system. PROVIEW monitors comply with VESA DDC (Display
Data Channel) Standards and are Plug & Play compatible. With the use
of a DDC compatible video card, the EDID (Extended Display
Identification) can be read from the PROVIEW Monitor by Plug &
Play compatible software, such as Windows '95/98. In order for
Windows '95/98 to detect the new monitor, you must ensure that the
following minimum requirements are met:

1) A DDC compatible video card is installed.
If your video card is not DDC compatible, then
autodetection will not work.

2) DDC detection is enabled in Windows '95/98.
This should be the case if you installed a DDC
compatible video card. The *.INF file supplied
with the video card should enable DDC in Windows '95/98.
If this is not the case, then autodetection will
fail.

3) A DDC compatible monitor with its *.INF file installed
into Windows '95/98.

2.0 Installing the *.INF file
========================================
Use the mouse and click in the following order:

1).To push mouse's right buttom on Wallpaper of computer's
Background then select "Properties" to adjust Display Properties. Or
you can go through Display icon on Control Panel.
2).Select "Settings" function.
3).To click "Change Display Type" to change your monitor type.
4).To click "Change" on Monitor Type, NOT Adapter Type, please note.
5).To click "Have Disk" function on Select Device table.
6).On Install From Disk table, please click "Browse" then select
Drives to disk C and Folders to "c:\proview" to find out the Win95/98
driver's information of "proview.inf".
7) Confirm the details to finish the installation.


The correct model for your monitor should be displayed if the
requirements for DDC detection are met, otherwise, choose
your monitor from a list of monitors.
Choose "OK" and closed all windows.


3.0 TroubleShooting
====================

Problem: AutoDetection doesn't work.
Solution:
Is DDC enable in Windows '95/98?

1).(Right Click) My Computer
2).--Properties
3).--Device Manager
4).--Monitor

If "Unknown Monitor" is displayed, then the problem
could be:

1).Damaged or wrong video cable?
2).Bad EDID data?
3).Non-DDC video card?
3).DDC detection is not enabled in Windows '95/98?

If "Plug and Play Monitor (VESA DDC) " is displayed, then
DDC is enabled, but the *.INF files was not correctly
installed or the *.INF file might be damaged.
Run installation procedure again or obtain the latest copy
of the *.INF file.

	Filename	Size	Readme	O.S.	Description
	proviewpnp.exe	31KB	proviewpnp.htm		These are Windows 95 monitor INF files for Proview monitors For help on installing monitor drivers, reference This page