-----------------INSTALLATION GUIDE of CDR-100 CD-ROM DRIVES-------------------
1. HARDWARE REQUIREMENT
IBM PC/AT compatible
CPU : 80386 or higher
256K byte free EMS memory
EMS version 3.2 or higher
2.DEVICE DRIVER DESCRIPTION
SANYO.SYS >>>> using EMS memory device driver
3. How to install CDR-100
(1) Add ANSI.SYS (IN DOS) to yuor computer's CONFIG.SYS file.
DEVICE=C:\DOS\ANSI.SYS
(2) Copy MSCDEX.EXE to the C:\DOS subdirectory on your computer's hard drive.
NOTE: If you use MS-DOS 6.0 or above,there is no need to copy this file
since MS-DOS already provides this file.
(3) Reboot your computer system.
(4) Insert CD-ROM install diskette to A or B floppy drive.
(5) Type INSTALL.BAT (Enter)
4. Add the following lines to your computer's CONFIG.SYS files.
DEVICE=C:\DOS\EMM386.EXE RAM 1024
NOTE: If this line already exist, please modify it as show above.
DEVICEHIGH= C:\SANYO.SYS /D:MSCD001 /DI:10 /EI:11 /A:300
NOTE: Make sure the Interface Card interrupt jummper's match these setting.
5. Add the following line to your computer AUTOEXEC.BAT FILE.
LH C:\DOS\MSCDEX /D:MSCD001 /M:10 /V
6. Restart your computer.
-------------------------------------------------------------------------------
1994/07/31
Filename | Size | Readme | O.S. | Description | |
jamicon.zip | 46KB | jamicon.htm | This is the DOS driver for the Jamicon CDR-100 CDROM. |
style="display:inline-block;width:336px;height:280px"
data-ad-client="ca-pub-5193782351433030"
data-ad-slot="2063583586">